lagging angle
英 [ˈlæɡɪŋ ˈæŋɡl]
美 [ˈlæɡɪŋ ˈæŋɡl]
网络 滞后角
双语例句
- The influence of the leading angle ( lagging angle) of the current reference signal the parameters and drive mode of the system to the dynamic characteristics are analyzed.
着重分析了电流参考信号超前角（滞后角）、系统参数和驱动方式对无刷直流电动机系统动态性能的影响。 - For the grinding wheel spindle system under some fix condition, pre balancing measures unbalance vibration amplitude ratio as well as the lagging angle between the vibration of bear support and the unbalance of grinding wheel spindle system.
对一定安装条件的砂轮-主轴系统，通过预平衡测定不平衡量与轴承座振动幅值的比例常数及振动量相对于不平衡量的滞后角。 - In the condition of eliminating the lagging strain of angle iron, the magnitude of pre-stress putting on the angle iron has litter impact on the ultimate bearing capacity of structure.
在消除角钢应变滞后的条件下，对角钢施加预应力的大小对结构最终承载力无明显影响。 - The study shows that the output pulse value of resistance absorption equipment is related to the chopper switch conduction ration and the selection of lagging angle.
研究表明，地面电阻吸收装置的输出电流脉动与斩波器的导通比、各支路斩波器的开关滞后角有关。 - Compared the results of theoretical calculation and numerical simulation, the theoretical formula of lagging angle is confirmed. The study results can provide reference for lagging angle design of combined valve. 4.
将理论计算结果与数值模拟结果进行比较，验证了组合阀滞后角理论公式的准确性，可为往复式油气混输泵组合阀滞后角的设计计算提供参考。 - This paper does some theoretical and numerical simulation research about flow field and lagging angle of combined valve, input power of the pump. At last, the operating characteristic of combined valve under gas-liquid two-phase condition is presented.
本文以该泵用组合阀为研究对象，分别从阀内流场、阀滞后角、泵输入功率等方面进行理论分析及数值模拟研究，初步掌握了该组合阀在气液两相工况下的工作特性。 - Use the mount lumped parametric model of the dynamic characteristics of hydraulic mount simulation, including mount vertical dynamic stiffness and lagging Angle, and at the same time, to the simulation results and experimental results verify the validity of the model is compared.
运用悬置的集总参数模型对液压悬置的动特性进行仿真，包括悬置垂向动刚度以及滞后角，同时将仿真结果与试验结果进行对比验证模型的有效性。 - Through the test method of a certain type of hydraulic mount and mount rubber Lord spring of dynamic stiffness and the frequency of the lagging Angle of change and change characteristics, and will both static and dynamic stiffness, lagging Angle, comparing the difference between are analyzed.
通过试验方法研究了某型液压悬置及悬置橡胶主簧的动刚度和滞后角的频变和幅变特性，并将两者的动静刚度、滞后角进行对比，分析两者之间的差别。 - Through the dynamic compression test, analyzed the rubber asphalt in different frequency load under dynamic compressive modulus and the lagging phase angle change rule.
通过动态压缩试验，分析了橡胶沥青在不同频率荷载下动态压缩模量和滞后相位角？的变化规律。